Table of Contents
Advertisement
Advanced Graphic Data Manager
"Application"
menu items
Color printer
Print direction
Only possible using a "RS232"
printer
Characters/line
Only possible using a "RS232"
printer
Blank rows at end
Only possible using a "RS232"
printer
Paper size
Fault switches
Configurable parameters
(factory settings are highlighted in bold)
Please set up if you´re using a black and white or a color printer.
Picklist: Yes (=color printer), No (=b/w printer)
Select the printing direction based on the properties of the printer you
use.
Picklist: Start first line, Start last line
Specify the maximum number of characters per line here.
Factory setting: 40
Enter the number of blank rows needed at the end of the printout to
make it easier to tear off the printed data.
Factory setting: 0
Please select the paper format of your printer.
Picklist: DIN A4, US Letter
You can switch a relay if an error occurred when printing out. The relay
remains switched until the printer is ready again or the device is
restarted.
Picklist: not used, relay x (xx-xx)
Note: If there are several reasons for triggering a relay (e.g. 2 different
limit values), this must be set to "Collective relay" under "Setup ->
Outputs -> Relay -> Relay x".
Commissioning and use during operation
67025/000
67030/000
67035/000
67040/000
67000/000
67005/000
Direct
access
code
81
Advertisement
Table of Contents
