Table of Contents
Advertisement
Advanced Graphic Data Manager
M-code error messages:
Code
Brief error description
M102
Overrange
M103
Underrange
M104
Measured value is invalid
M304
SD card is full!
M305
USB stick is full!
M308
SD card is write-protected!
M330
Not all USB units could be switched on since the
max. current limiting level was reached.
M331
SIM card is blocked
M432
Analog card x is not calibrated!
F-code error messages:
Code
Brief error description
F101
Cable open circuit
F306
File not found or is corrupt!
F307
Parameter file not found or is corrupt!
F309
Analog card x is out of order!
F310
Digital card is out of order!
F311
Power unit is out of order!
F312
Fieldbus card is out of order!
F313
Screenshot could not be saved!
F314
Error occurred when calibrating!
F315
Cannot save run times!
F316
Cannot save setup to file!
F317
Cannot save unit data!
F318
Cannot save user administration!
Remedial action
Check sensor
Check sensor
Check formula of the mathematics channel;
Check unit hardware
Replace SD card
Replace USB stick
Disable write protection on SD card
Use active USB hub (hub with own power supply)
Unlock SIM card by entering the PUK number. Note:
The PUK must be entered using a cellular phone (not
possible to enter number using the unit)!
Calibrate the analog card (technical personnel only) or
contact the service department of the supplier!
Remedial action
Check connections and sensor
Replace the analog card or contact the service
department of the supplier! Switch the unit off and
then on again if necessary.
Replace the digital card or contact the service
department of the supplier! Switch the unit off and
then on again if necessary.
Replace the power unit or contact the service
department of the supplier! Switch the unit off and
then on again if necessary.
Contact the supplier's service department! Switch the
unit off and then on again if necessary.
Change the SD card or USB stick and try again
Repeat the calibration
Contact the supplier's service department!
Contact the supplier's service department!
Contact the supplier's service department!
Contact the supplier's service department!
Troubleshooting
123
Advertisement
Table of Contents
