Chapter 1 Ellipse™ 3000 Installation Guide
Ellipse 3000 User Guide
Power Cable
NOTE: If the Ellipse 3000 contains the Quad HW board, 8 audio cables are included too!
CAUTION: If anything is missing or damaged, do not continue with the installation.
Installation Instructions
This section explains the mechanical installation of an Ellipse 3000 unit in a standard equipment
rack.
Installing the Unit in a Rack
NOTE: For rack installation, ensure that a designated 19" rack is fully prepared for installation. Ensure
sufficient space behind the rack for easy access for installation and maintenance.
The following sections detail the installation of an Ellipse 3000 unit in a 19" rack using the
dedicated mounting slides.
Installing the Brackets
To prepare the Ellipse for rack installation:
1. Fasten a pair of brackets to both side rails of the rack housing by using two flat washer screws
for each side.
2. Use the two front holes at the sides of the housing to attach the bracket. (Complementing
nuts are already installed on the inner side of the holes, but the four screws required are not
included in the supplied kit).
3. Ensure proper grounding of the rack assembly to prevent potential electrical problems (See
Rack Grounding Connection
© 2014 Harmonic Inc. All rights reserved.
Item
for details on grounding the unit to a rack mount).
7
Installation Instructions
Quantity
1 Shared CD
1 unit
Ellipse 3000 Release 3.3, Rev A