Stream Filtering Configuration; Filtering Using The Front Panel Interface - Harmonic ProView 2900 Installation Manual

Chapter 7: Stream Configuration Menu
7.5.

Stream Filtering Configuration

Stream Filtering is a licensing-required feature that allows the user to define a method for
Service and PID filtering on streams delivered at the ProView 2900 ASI and IP output ports.
The following describes the filtering procedures, using both front panel and web-based
management interfaces:

7.5.1. Filtering Using the Front Panel Interface

To use filtering mode through the front panel perform the following:
1. Configure ASI and/or IP outputs to filtering mode (see section 7.3). To access the
After Filtering submenus go to:
Configuration Stream Output ASI Output Source After Filtering or
Configuration Stream Output IP Output Source After Filtering
2. Access the filtering menu by the following path:
Root Configuration Stream Filtering
1 1 1 1 General General General General
2 2 2 2 Service Service
Service Service
3 3 3 3 PID PID PID PID
3. Set the following General sub menu parameters: strategy, mode, Bit-rate mode
and bit-rate. (see section 7.5.3). To access the General submenus go to:
Configuration Stream
4. In case that the service filtering strategy is selected, set the required services
(see section 7.5.4). To access the Service submenus go to:
Configuration Stream
5. In case the PID filtering strategy is selected, set the required PIDs (see section
7.5.5). To access the General submenus go to:
Configuration Stream
© Harmonic Inc. Manual p/n 101543/Ver 1.0
Filtering Filtering
Filtering Filtering
Filtering General
Filtering Service
Filtering PID
7-10
Stream Filtering Configuration
1 1 1 1 - - - - 2 2 2 2 - - - - 2 2 2 2 - - - - 4 4 4 4
ProView 2900 Series/SW Version 1.94