Procedures For Disassembly And Assembly - Epson AcuLaser C2600 Service Manual

EPSON AcuLaser C2600/2600

4.2 Procedures for Disassembly and Assembly

This section explains the procedures for disassembling the product. Unless otherwise
stated, reassembly should be carried out in the reverse order of the disassembly
procedure. As a general rule, options must be removed before starting work, however,
performing maintenance with options installed is also allowed if there is no need to
remove them.
When performing work on parts that are controlled as spare parts
C A U T I O N
and have no disassembling procedures explained in this manual,
fully observe those parts to recognize how they are attached before
starting work.
Refer to the articles below for disassembly and assembly procedures.
Expressions related to directions mentioned in procedures are defined as follows:
FRONT: Near Side direction facing the front side of the printer
(Consumable parts side)
REAR: Far side direction facing the front side of the printer
(I/F Connector side)
LEFT: Left direction facing the front side of the printer
(Paper Eject side)
RIGHT: Right direction facing the front side of the printer
(MP tray side)
LEFT
FRONT
Figure 4-1. Description of Directions
Disassembly and Assembly
REAR
RIGHT
04000401
Procedures for Disassembly and Assembly
Interpretation of Figures
The following explains the meaning of the numbers and symbols used in the
figures given in this chapter.
"1": Indicates the first disassembling procedure in the section.
"1)": Indicates the second disassembling procedure in the section.
"1]": Indicates the third disassembling procedure in the section.
Depending on the section, figures for both the disassembling and reassembling are
provided. In such case, the step numbers are given as shown below.
"D1": Indicates the first disassembling procedure in the section.
"D1)": Indicates the second disassembling procedure in the section.
"A1": Indicates the first reassembling procedure in the section.
"A1)": Indicates the second reassembling procedure in the section.
Black arrows on disassembling figures indicate that the part should be moved in
the indicated direction. Process numbers that are marked beside black arrows
correspond to process order described in the text.
White arrows contained in disassembling figures indicate front side of the
equipment.
For details of positions of connectors (P/J), refer to
and Jack Layout (p.411)".
Connector numbers (e.g. 211X) correspond to
Jack Layout (p.411)".
Revision B
"7.1.1 Connectors and Plug
"7.1.1 Connectors and Plug and
216