EPSON AcuLaser C2600/2600
4.5.9.2 PULLEY ASSY., DRIVE
REMOVAL
D1. Remove the BOARD ASSY., MAIN C585 MCU.
D2. Release the harness from both the retainer of the PULLEY ASSY., DRIVE and the
edge saddle.
D3. Remove the 3 screws that secure the PULLEY ASSY., DRIVE.
C.P.POLYWAVEA,3x6,F/Zn: 3
D4. Disengage the gear of the PULLEY ASSY., DRIVE from the TIMING BELT, and
remove the PULLEY ASSY., DRIVE.
REINSTALLATION
A1. Loosen the two screws that secure the BRACKET, IDLE.
C.P.POLYWAVEA,3x6,F/Zn: 2
A2. Engage the gear of the PULLEY ASSY., DRIVE with the TIMING BELT.
A3. Insert the 2 BUSHING, 8 of the PULLEY ASSY., DRIVE to the shaft, and match
the 2 positioning holes of it with the dowels.
A4. Secure the PULLEY ASSY., DRIVE with the three screws.
C.P.POLYWAVEA,3x6,F/Zn: 3
A5. Secure the BRACKET, IDLE with the two screws.
C.P.POLYWAVEA,3x6,F/Zn: 2
A6. Route the harness through the retainer of the PULLEY ASSY., DRIVE and the
edge saddle.
A7. Attach the BOARD ASSY., MAIN C585 MCU.
Disassembly and Assembly
(p.310)
(p.310)
Disassembling/Assembling the Main Unit
D2
D2
A3
Figure 4-86. Removal of PULLEY ASSY., DRIVE
Revision B
TIMING BELT
PULLEY ASSY.,
DRIVE
D4
D3
D3
D3
A1,
A5
A1,
A5
04013901
295