EPSON AcuLaser C2600/2600
When performing the following work, pay attention to the
C A U T I O N
instructions below.
Do not touch the ROLLER, 2ND with bare hands.
The ROLLER, 2ND and the ROLLER, GATE should not be
damaged.
Do not pull the 2ND TRANSFER Assy., ASP, forcedly, as the
HARNESS HV, 2ND TRANSFER is connected to it.
6.
Slide the 2ND TRANSFER Assy., ASP toward rear, draw out the front shaft first
and the rear shaft next to remove it.
4.
Put the front side of the 2ND TRANSFER Assy., ASP on the rib of
the frame.
7.
Disconnect the connector of the HARNESS, HV, 2ND TRANSFER from the
electrode.
8.
Matching the HARNESS, HV, 2ND TRANSFER with the 2 holes of the 2ND
TRANSFER Assy., ASP and pull out the HARNESS, HV, 2ND TRANSFER.
9.
Release the harness of the Post-transferring sensor from the tab of the 2ND
TRANSFER Assy., ASP.
10. Remove the BUSHING, 8 (rear) from the 2ND TRANSFER Assy., ASP.
Disassembly and Assembly
Reassembly
Disassembling/Assembling the Main Unit
8
9
6
4
Figure 4-83. Removal of 2ND TRANSFER Assy., ASP 2
Revision B
7
10
2ND TRANSFER Assy., ASP
04006601
292