Epson AcuLaser C2600 Service Manual page 359

EPSON AcuLaser C2600/2600
4.6.2.4 CONNECTOR, DUPLEX; B
1. Remove the Duplex unit. (p.355)
2. Remove the screw that secures the COVER, CONNECTOR, slide it toward left to
release the tab, and remove the COVER, CONNECTOR.
C.C.P-TITE SCREW,3x8,F/Zn: 1
1. Pass the HARNESS, DUPLEX through the place shown in
4-150 so as not to be pinched by the COVER, CONNECTOR.
3. Disconnect the connector of the HARNESS, DUPLEX from the CONNECTOR,
DUPLEX; B.
2. When connecting the connector of the HARNESS, DUPLEX to the
CONNECTOR, DUPLEX; B, make sure to push in the connector
all the way seated as it may stop halfway.
4. Release one tab of the CONNECTOR, DUPLEX; B at a time (2 places in total) to
remove the CONNECTOR, DUPLEX; B.
When installing the CONNECTOR, DUPLEX; B, make sure to
C A U T I O N
insert one tab at a time. Inserting the two tabs at once may damage
the component.
Disassembly and Assembly
COVER, CONNECTOR
Figure
Reassembly
Disassembling/Assembling the Options
2-1
1
2-2
4-1
Figure 4-150. Removal of CONNECTOR, DUPLEX; B
Revision B
3
4-2
4-1
CONNECTOR, DUPLEX; B
04013301
359