Epson AcuLaser C2600 Service Manual page 291

EPSON AcuLaser C2600/2600
4.5.7.7 2ND TRANSFER Assy., ASP
1. Remove the TRANSFER UNIT, Assy., ASP.
2. Remove the 2 screws that secure the COVER, DETECTOR ASSY. to remove the
COVER, DETECTOR ASSY.
C.C.P-TITE SCREW,3x8,F/Zn: 1
1. Insert the detection lever of the COVER, DETECTOR ASSY. to
the hole.
2. Match the rib of the COVER, DETECTOR ASSY. with the notch.
3. Disconnect the connector (Blue 3 Pin) from the Post-transferring sensor, and
release the harness from the 3 tabs and the 2 grooves.
4. Disconnect the connector of the HARNESS, HV, 2ND TRANSFER from the
electrode, and release the connector from the 2 grooves.
3. Route both the harness of the Post-transferring sensor and the
HARNESS, HV, 2ND TRANSFER as shown in
5. Remove the E-RING, 7, L/NA that secures the BUSHING, 8 (rear).
Disassembly and Assembly
(p.284)
Figure 4-82.
Disassembling/Assembling the Main Unit
4-1
3-1
3-2
3-2
4-2
3-2
4-2
3-2
COVER,
2
DETECTOR ASSY.
Reassembly 1
Reassembly 2
Detection
Lever
Figure 4-82. Removal of 2ND TRANSFER Assy., ASP 1
Revision B
2
5
04006502
291