Epson AcuLaser C2600 Service Manual page 257

EPSON AcuLaser C2600/2600
REINSTALLATION
A1. Hitch the 3 tabs of the Paper eject sensor to the attachment holes of the COVER,
TOP.
A2. Connect the connector to the Paper eject sensor and route both the harness and the
grounding wire through the 3 grooves of the COVER, TOP.
When performing the following work, be careful not to pinch the
C A U T I O N
harness or the grounding wire.
A3. Match the 2 positioning holes of the GUIDE, PAPER EJECT with the dowels, and
secure the GUIDE, PAPER EJECT with 7 screws.
C.C.P-TITE SCREW,3x10,F/Zn: 7
A4. Match the attachment shaft and the notch on the right end of the EJECT ROLLER
UNIT with the positioning hole and the dowel, and then attach the MOUNTING
PLATE to the left end of the shaft of the ROLLER UNIT.
A5. Secure the EJECT ROLLER UNIT with a screw.
C.B.P-TITE SCREW,3x8,F/Zn: 1
A6. Insert the 2 tabs of the DUCT, PAPER EJECT, LOWER to the notches of the
EJECT ROLLER UNIT, and match the positioning hole of the DUCT, PAPER
EJECT, LOWER with the dowel.
A7. Secure the DUCT, PAPER EJECT, LOWER with the screw.
C.C.P-TITE SCREW,3x10,F/Zn: 1
A8. Attach the COVER ASSY., FU.
Disassembly and Assembly
(p.242)
Disassembling/Assembling the Main Unit
DUCT, PAPER EJECT,
LOWER
A4-2
A5
EJECT
ROLLER UNIT
A3-2
A3-2
A3-2
A3-1
A1
A2-1
A2-2
A2-2
A2-2
Figure 4-48. Reinstallation of Paper Eject Sensor
Revision B
A6-1
A6-2
A6-1
A7
A3-2
A3-2
A3-2
A3-2
GUIDE,
PAPER EJECT
Paper Eject
Sensor
COVER, TOP
A3-1
A4-1
04003601
257