Disassembly/Assembly Procedures - Epson ColorPage EPL-C8200 Service Manual

EPSON ColorPage EPL-C8200

3.2 Disassembly/Assembly Procedures

This section describes procedures for disassembling/assembling the
printer. Unless otherwise specified, assembly can be performed by
reversing the disassembly procedure. Refer to Section 3.3 for
adjustment procedure. In principle, you are to remove all options before
servicing. However, you can leave them if possible.
Some parts are listed as spare parts but not mentioned
in disassembly/assembly procedure. Therefore, look
carefully how they are installed before you removing
them.
NOTE: Directions used in this section are defined as shown in the figure
below:
Figure 3-1. Directions
Chapter 3 Disassembly and Assembly/Adjustment
Refer to the followings which explain descriptions used in this chapter.

Regarding "(PL X, Y, Z)" at the end of each heading of removal
sections, it corresponds to the numbers in the part list in
Appendix. Referring to the numbers, you can find the
appearance and location of the parts efficiently.

Directions are described as mentioned below.
(See Figure 3-1.)


Front: Front side viewing the printer toward its front side


Back: Rear side viewing the printer toward its front side


Left: Left hand side viewing the printer toward its front side


Right: Right hand side viewing the printer toward its front
side

Screws are mentioned with descriptions including "(mounting
location, color, feature, thread part length, and so on)".

"Z)" in a drawing corresponds to the step "Z" of the section.

Fasten the screws in the drawings using a Philips screw driver
if no instruction is given.

If black arrows are shown with numbers, they show the order to
act for the step.

White arrows (FRONT) in the drawings show the front side of
the printer.

Refer to Appendix for the connector (P/J) locations and
harness routings.

The generic term "Developer Assembly" is used for
"DEVELOPPER ASSEMBLY Y", "DEVELOPER ASSEMBLY
M", "DEVELOPER ASSEMBLY C", AND "DEVELOPER
ASSEMBLY K".

The generic term "TONER CARTRIDGE" is used for "TONER
CARTRIDGE Y", "TONER CARTRIDGE M", "TONER
CARTRIDGE C", and "TONER CARTRIDGE K".
Revision A
3-3