EPSON AcuLaser C2600/2600
4.5.10.12 HARNESS, INLET
1.
Remove the MOUNTING PLATE ASSY., CONTROLLER, UNIT.
2.
Remove the R/W MODULE, B5J-0111.
When performing the following work, pay attention to the items
C A U T I O N
described below.
Once a toner cartridge is removed, the FRAME ASSY., RT
becomes unstable and rotates violently. So as not to hurt your
fingers, rotate the FRAME ASSY., RT by turning the section
where the R/W MODULE, B5J-0111 was attached.
Make sure to rotate the FRAME ASSY., RT in the direction
of the arrow (counter clockwise direction).
Make sure to turn the power off before removing/installing
toner cartridges.
Never touch the Developer roller.
3.
Press up the lock lever of the LOCK ASSY., RT to unlock the lock of the FRAME
ASSY., RT, remove one toner cartridge by rotating the FRAME ASSY., RT to the
toner cartridge replace position, and turn the FRAME ASSY., RT so the part with
no cartridge faces downward.
Disassembly and Assembly
(p.314)
(p.316)
Disassembling/Assembling the Main Unit
LOCK ASSY., RT
3-1
FRAME ASSY., RT
3-2
Figure 4-112. Removal of HARNESS, INLET 1
Revision B
3-4
Toner Cartridge
3-3
04014501
321