Epson AcuLaser C2600 Service Manual page 317

EPSON AcuLaser C2600/2600
REINSTALLATION
POWER SWITCH, SDDJF30200
A1. When performing the following work, do not mistake the ON/OFF
C A U T I O N
direction of the POWER SWITCH, SDDJF30200.
A1. Insert the POWER SWITCH, SDDJF30200 into the HARNESS, ASSY., INLET
and secure them with the 4 tabs.
A2. When performing the following work, pay attention to the
C A U T I O N
instructions below.
Turn the ribs of each connector toward outside of the POWER
SWITCH, SDDJF30200.
The black harness should be at the bottom.
The red connector and the white connector should be connected
to the red port and the white port respectively.
A2. Connect the connector to the POWER SWITCH, SDDJF30200.
A3. Secure the two red connectors with a piece of acetate tape.
A3. A HARNESS, INLET provided as an After Service part does not
C A U T I O N
include the acetate tape. Be careful not to forget to secure the red
connectors with the piece of acetate tape used for the previous part
or with new one.
A4. Press the connector into the notch of the DUCT, EX, match the 2 positioning holes of
the HANDLE ASSY., LEFT, UNIT with the dowels, and secure them with 4 screws.
C.P.POLYWAVEA,3x6,F/Zn: 4
A5. Attach the HOUSING, LEFT. (p.245)
R/W MODULE, B5J-0111
A1). Match the 2 positioning holes of the R/W MODULE, B5J-0111 with the dowels,
and secure them with 2 screws.
C.C.S-TITE SCREW,3x5,F/Zn: 2
A2). Connect the connectors (White 2 Pin, Pale Orange 7 Pin) to the R/W MODULE,
B5J-0111.
A3). Insert the rib of the COVER, CS to the frame, match the positioning hole with the
dowel, and secure the COVER, CS with a screw.
C.C.S-TITE SCREW,3x5,F/Zn: 1
Disassembly and Assembly
A4). Attach the HOUSING, LEFT.
R/W MODULE,
B5J-0111
A3)-1
A3)-3
A4-3
A4-3
Figure 4-108. Reinstallation of POWER SWITCH, SDDJF30200/
Disassembling/Assembling the Main Unit
(p.245)
A1)-1
A3)-2
A1)-1
A1)-2
A4-2
A4-1
A1
POWER SWITCH,
SDDJF30200
A4-3
A2
A4-3
A3
Rear
R/W MODULE, B5J-0111
Revision B
A2)
A2)
A4-2
Caution A1
Front
04009102
317