Epson AcuLaser C2600 Service Manual page 328

EPSON AcuLaser C2600/2600
4.5.11.6 PAPER GUIDE, FRONT, MP/LIFT PLATE, MP/
PAPER GUIDE, REAR, MP
REMOVAL
D1. Remove the LIFT PLATE ASSY.
D2. Slide the PAPER GUIDE, FRONT, MP and the PAPER GUIDE, REAR, MP,
ASSY. outward and then check the cursor position. Memorize the position as it is
required during assembly.
D3. Slide the PAPER GUIDE, FRONT, MP and the PAPER GUIDE, REAR, MP,
ASSY. to the minimum paper width location.
When removing the screws in order described bellow, MOUNTING
C A U T I O N
PLATE ASSY., PINION and the SPUR GEAR 16, MPT falls off
from behind the LIFT PLATE, MP. Place the LIFT PLATE, MP on
a desk or work table before doing the work.
D4. Remove the screw that secures the MOUNTING PLATE ASSY., PINION to
remove the MOUNTING PLATE ASSY., PINION and the SPUR GEAR, 16, MPT.
C.C.SCREW,3x6,F/Uc: 1
D5. Lift the tip of the PAPER GUIDE, FRONT, MP in the direction of the arrow, and
unloose the salient of the PAPER GUIDE, FRONT, MP from the LIFT PLATE, MP.
D6. Uprear the PAPER GUIDE, FRONT, MP vertically at the concave position of the
slit, and remove the LIFT PLATE, MP by rotating in the direction of the arrow.
D7. Remove the PAPER GUIDE, REAR, MP ASSY. using the same procedure for the
PAPER GUIDE, FRONT, MP (step
When performing the following work, take care not to lose the
C A U T I O N
COMPRESSION SPRING, 8.51.
D8. Press the LEVER, GUIDE, MP from backside of the PAPER GUIDE, REAR, MP
to release the two dowels, and remove both the LEVER, GUIDE, MP and the
COMPRESSION SPRING, 8.51.
Disassembly and Assembly
(p.327)
D5 and D6).
Disassembling/Assembling the Main Unit
PAPER GUIDE,
FRONT, MP
D3
D2
Cursor position
checking point
D6-1
D6-2
LIFT PLATE, MP
PAPER
GUIDE,
REAR, MP
D7
D8
Dowel
LEVER, GUIDE, MP
COMPRESSION SPRING,8.51
Figure 4-119. Removal of PAPER GUIDE, FRONT, MP/LIFT PLATE, MP/
PAPER GUIDE, REAR, MP
Revision B
D4-1
PAPER GUIDE,
REAR, MP
D3
SPUR GEAR, 16, MPT
MOUNTING PLATE ASSY., PINION
D5-1
PAPER GUIDE,
FRONT, MP
D6-3
D5-2
04010102
328