EPSON AcuLaser C2600/2600
4.5.7.3 CLUTCH, CLEANER
1.
Remove the HOUSING, REAR.
2.
Remove the Fuser unit.
(p.237)
3.
Disconnect the connector (White 6 Pin) from the STEPPING MOTOR ASSY.,
DV.
4.
Disconnect the connector (Blue 2 Pin) from the BOARD ASSY., DRV, C585
DRV.
5.
Disconnect the 4 connectors from the relay connectors of the DUCT ASSY., FU.
TRANSFER UNIT, Assy., ASP connector (White 8 Pin)
HARNESS, MAIN connector
HARNESS, MAIN connector
COVER ASSY., FU connector
6.
Release the HARNESS, MAIN from the 11 tabs and the groove of the DUCT
ASSY., FU.
1.
Move the cable tie of the HARNESS, MAIN to the position as
shown in
Figure
4-71.
7.
Disconnect the connector (White 3 Pin) of the FAN, FU from the BOARD ASSY.,
MAIN C585 MCU.
Disassembly and Assembly
(p.244)
(White 3 Pin)
(White 8 Pin)
(White 3 Pin)
Disassembling/Assembling the Main Unit
6
7
Reassembly
1
Figure 4-71. Removal of CLUTCH, CLEANER 1
Revision B
6
5
5
5
5
6
3
6
4
04005401
279