EPSON AcuLaser C2600/2600
4.5.6.2 LOCK ASSY., RT
1.
Remove the MOUNTING PLATE ASSY., CONTROLLER, UNIT.
2.
Remove the one piece of acetate tape that secures the HARNESS, MAIN.
3.
Disconnect the connectors (White 2 Pin) from the BOARD ASSY., DRV, C585
DRV.
4.
Disconnect the connector (White 4 Pin) from the relay connector.
5.
Release the HARNESS, MAIN and LOCK ASSY., RT from the 2 retainers.
1.
Move the cable tie that secures the HARNESS, MAIN to the
position as shown in
2.
Bend the harness of the LOCK ASSY., RT at the retainer to
secure it as shown in
Always sustain the LOCK ASSY., RT or it may fall off when
C A U T I O N
performing the following work.
6.
Remove the 3 screws that secures the LOCK ASSY., RT to remove the LOCK
ASSY., RT.
C.P.POLYWAVEA,3x6,F/Zn: 3
3.
Match the positioning hole of the LOCK ASSY., RT with the
dowel.
Disassembly and Assembly
(p.313)
Figure
4-64.
Figure
4-64.
Disassembling/Assembling the Main Unit
3
4
2
5
5
6-2
6-1
6-1
6-1
LOCK ASSY., RT
Figure 4-64. Removal of LOCK ASSY., RT
Revision B
Reassembly 1,
2
Reassembly
3
04004701
272