Epson AcuLaser C2600 Service Manual page 75

EPSON AcuLaser C2600/2600
THE LOWEST DESCRIPTION SECTION OF THE STATUS SHEET
1. Firmware version in DDYM format beginning with IA
2. Type of code ROM device
*: Flash
space: Mask ROM
Always "*" in the case of this printer.
3. Version of CMTD in 4 digits beginning with A or @.
4. Version of mechanical controller of the engine in 10 digits beginning with MC.
5. USB ID
A string of 18-digit alphanumeric characters with the below format.
29: Fixed value
P: Fixed value
Digits 4 to 7: Product code
Digits 8 to 13: 6-digit serial number
14 digits: Last digit of the year (4 for 2004)
Digits 15 to 16: Month of production (01, 02, ..., 11, 12)
Digits 17 to 18: Day of production (01, 02, ..., 30, 31)
The information is written in the main unit assembly line. All 18 digits are "*" before
any value is written.
6. Latest connection status of the USB communication mode
H: HS
F: FS
space: No USB connection
7. USB's communication mode
D: D4 compliant device connected
space: non D4 compliant device
8. Type-B level
3: Type B with L3 support
space: other than L3
Product Description
9. IEEE1284 negotiation result
e: ECP connection
n: Nibble
space: Compatibility
10. Number of jams in 6 digits beginning with JC.
11. Number of replacements (xxxxxxxxxxxx) and number of error recoveries
(yyyyyyyyyyyy) for each Toner cartridge beginning with IC.
Each 3-digit x or y correspond to C, M, Y, and K. xxxxxxxxxxxx and yyyyyyyyyyyy
are separated by a space.
In 4xB/W mode, the information on the three black cartridges installed in the C, M,
and Y positions are indicated corresponding to the position.
In B/W mode, the indicating style is the same as the color mode.
COLOR CALIBRATION INFORMATION
G: Increase Gradation, D: Increase Definition, 600: means 600 dpi. Displayed only
when calibration data is registered in EEPROM, and they mean calibration data for 600
dpi, Increase Gradation, etc. depending on the combination.
MMMM: Month, DD: Day, YYYY: Year, HH: Hour, MM: Minutes, and they indicate
the date and time the calibration data was created.
Status Sheet
Revision B
75