Epson AcuLaser C2600 Service Manual page 314

EPSON AcuLaser C2600/2600
4.5.10.7 HIGH VOLTAGE POWER SUPPLY, EUKMBE925HA
1. Remove the HOUSING, LEFT.
2. Disconnect the all 4 connectors (White 18 Pin, White 4 Pin, White 7 Pin, White 14
Pin) on the BOARD ASSY., MAIN C585 MAIN.
3. Remove the screw that secures the grounding wire.
C.P.POLYWAVEA,3x6,F/Zn: 1
1. Route the grounding wire above the connectors on the BOARD
ASSY., MAIN C585 MAIN.
4. Remove the BUSHING, 0CB-500 from the MOUNTING PLATE ASSY.,
CONTROLLER, UNIT. Then remove the HARNESS,PANEL from the gaps of
both the BUSHING, 0CB-500 and the MOUNTING PLATE ASSY.,
CONTROLLER, UNIT.
5. Remove the 6 screws that secure the MOUNTING PLATE ASSY.,
CONTROLLER UNIT.
C.P.POLYWAVEA,3x6,F/Zn: 4
6. Remove the all harnesses from the notch of the MOUNTING PLATE ASSY.,
CONTROLLER UNIT, and remove the MOUNTING PLATE ASSY.,
CONTROLLER UNIT, together with the BOARD ASSY., MAIN C585 MAIN.
7. Disconnect the all 7 connectors (White 12 Pin, Harness, HV, 2ND TRANSFER (x
3), Harness, HV, 1ST TRANSFER (x 1), ELECTRODE Assy., PC (x 2)) on the
HIGH VOLTAGE POWER SUPPLY, EUKMBE925HA.
Always sustain the HIGH VOLTAGE POWER SUPPLY,
C A U T I O N
EUKMBE925HA or it may fall off when performing the following
work.
8. Remove the 5 screws that secure the HIGH VOLTAGE POWER SUPPLY,
EUKMBE925HA, and remove the HIGH VOLTAGE POWER SUPPLY,
EUKMBE925HA and the SHEET, INSULATION, HIGH VOLTAGE.
C.P.POLYWAVEA,3x6,F/Zn:
C.C.P-TITE SCREW,3x8,F/Zn:
Disassembly and Assembly
(p.245)
4
1
Disassembling/Assembling the Main Unit
5
5
Figure 4-105. Removal of HIGH VOLTAGE POWER SUPPLY, EUKMBE925HA
Revision B
7
7
7
7
7
5
8
8
8
8
5
8
HIGH VOLTAGE
POWER SUPPLY,
EUKMBE925HA
SHEET, INSULATION,
HIGH VOLTAGE
5
6-1
2
2
2
3
7
7
4-2
4-1
2
04008802
314