EPSON AcuLaser C2600/2600
Procedure
Once file-receiving or rewriting operation is started on
the printer side, the data LED flashes and the message
"ROM P Writing" is displayed on the LCD panel.
When the transfer is complete, "completed" window pops
up. Click [OK].
7
Execute the update.
8
Confirm the checksum.
After confirming that the data LED of the printer is turned
9
Reboot the Printer.
off and the LCD panel displays "Ready", turn the printer
power off and turn back on again.
10
Print the status sheet.
Prints the status sheet.
Confirm that the program firmware version has been
Check the version on the
11
updated correctly by comparing the status sheet with that
status sheet.
printed in step 1. Refer to
Adjustment
Method 1
(RCC)
Confirm that both the old and new firmware versions are
displayed on the LCD, and press the [Right] button on the
control panel.
"Completion" pop-up window will be displayed when the
data transfer is finished. Click on the [OK].
When the program update is finished, the checksum will
be indicated on the LCD panel.
Confirm the checksum.
---
Pressing the [Right] button on the control panel reboots
the product.
Prints the status sheet.
Confirm that the program firmware version has been
updated correctly by comparing the status sheet with that
" 1.21 Status Sheet" (p.74)
printed in step 1. Refer to
Firmware Update
Method 2
(CRB)
Code=
XXXX, XXXX, XXXX, XXXX
Total=
XXXX, XXXX, XXXX, XXXX
" 1.21 Status Sheet" (p.74)
Revision B
LCD Panel
Program Device
Version XX.XX
Erasing Device
Program Device
Version XX.XX
PRG XXXXXXXX
Program Device
Version XX.XX
---
---
---
380