GTWIN Reference Manual
Item
Method
Number of
Replacements
Reference Device
Change Attribute for
Every Appearance
Description
Select how the custom part's appearance is to be changed.
ON/OFF. Since only 2 states are possible, the custom part can only assume 2
different appearances. The change in appearance can be triggered by simply pushing
the switch (Push SW) or by the Reference Device.
Direct. The custom part's appearance changes in response to the reference device.
Digit. The custom part's appearance changes in response to the state of a specific bit
(digit) of the reference device.
The number of replacements, i.e. the number of appearances the custom part can
assume, depends on the method chosen and is indicated in parentheses.
If available, specify the type and number of the reference device.
Allows you to change the operation for each appearance of the custom part, i.e. for each
state of the reference device, via the "Element Setup (see p. 227)" tab.
5.11 Custom Parts
231