Panasonic GTWIN Reference Manual page 222

GTWIN Reference Manual
2. On the "Basic Setup" tab, make the settings as shown below
If you select "SD Card (Logging Data)" as the reference data, you need to
configure the time unit, too (see p. 217). You can set the number of plots within
the range displayed in the brackets underneath.
3. Select the "Element Setup" tab
The selected number of lines is listed.
4. Double-click the first line or select the line and then [Setup]
5. On the "Line Settings" tab, set the graph type
At least one line from the total number of lines needs to be set to "Bar Graph", if
the option "Bar Graph" on the "Basic Setup" tab has been set to "Yes".
6. Set the reference device and the data format
7. Set the maximum and minimum values
8. Select [OK]
9. Set the other line accordingly
When you have set up both lines, the list will look similar to this.
5.9 Line Graph Parts
221