Basic Communication Area To Plc - Panasonic GTWIN Reference Manual

Introducing GTWIN
Field
180 degrees rotation
Options for general purpose serial communication
Communication Mode

1.6.1.1 Basic Communication Area to PLC

Make sure that your PLC does not use the word or bit areas, i.e. addresses
assigned under "Basic Communication Area to PLC", for any other purpose!
24
Description
available for the following GT models: GT02, GT02L, GT03-E, GT05, GT12, GT32,
GT32-E.
Rotates the display of all screens by 180° when the GT panel is placed upside
down. Only available for the following GT models: GT03-E and GT32-E. This
function is also available when the GT panel is installed in portrait orientation.
Please set in accordance with the standard RS232C device you are using. Please
consult the manual of the device you are using for more information on the
communications mode.
Command Response. The RS232C device connected to the GT has the
transmission right, i.e. it transmits the control command to the GT and the GT
executes a process in accordance with that command. The command response
mode returns the result to the RS232C device.
Two-way 1. The RS232C device connected to the GT sends a control command to
the GT. Data such as switch operations and data settings is transmitted to the
RS232C device from the GT. In this mode, the GT does not reply to the command
from the connected RS232C device so execution time is shorter.
Two-way 2. The RS232C device connected to the GT sends a control command to
the GT. Data such as switch operations and data settings is transmitted to the
RS232C device from the GT. In this mode the GT replies to the command from the
connected RS232C device so execution time is longer. However, data transfer is
more secure as a result of confirmation or error messages.
GTWIN Reference Manual