Connecting To The Fp2/Fp2Sh Computer Communication Unit - Panasonic GTWIN Reference Manual

GTWIN Reference Manual 7.11 Connecting to the FP2/FP2SH Computer Communication Unit
7.11 Connecting to the FP2/FP2SH Computer
Communication Unit
DIP switch settings on reverse side of FP2 computer communication unit
If both serial ports of the FP2 computer communication unit are being used, each port should
be set individually as shown below.
SW No. Setting contents
1 Reserved for system
2 COM1 baud rate
3
4 COM1 data length
5 Reserved for system
6 COM2 baud rate
7
8 COM2 data length
With the FP2 CCU, the parity check is fixed at "Odd", and the number of stop bits is fixed at
"1bit".
Value Switch status
ON
9600bps OFF
ON
8 bits ON
ON
9600bps OFF
ON
8 bits ON
271