Panasonic GTWIN Reference Manual page 238

GTWIN Reference Manual
Error code Error
**1021 Unsupported PLC model
error
**1022 Password protection error
**1023 Master memory error (FP-X
only)
**1025 General-purpose memory
shortage
**1027 Remote mode error
(FP2/FP2SH only)
**102D Forced operation error
**1040 The record area for data
logging in the GT was
overwritten
There was an overflow of
the SRAM.
**1041 The record area for data
logging in the GT was
overwritten
**1042 The record area for data
logging in the GT was
overwritten
**1043 SD memory card writing
error
**1044 The record area for data
logging in the GT was
overwritten
**1045 The record area for data
logging cannot be reserved
in the SRAM
**1060 Index register value error
**1080 Start time device value
error
**1100 Ethernet IP address setting
error
**1101 Ethernet subnet mask
setting error
**1102 Ethernet default gateway
setting error
**1103 Ethernet port no. setting
Cause and solution
The selected PLC model is not supported.
 An incorrect password has been input three times or more.
Turn the power supply off and on again and then input the
correct password.
 Upload protection has been turned on for the PLC.

The number of digits was changed when a new password with
the FP monitor function was set. Cancel the password setting
before changing the number of digits.
A master memory has been installed in the FP-X. It is not possible
to transfer programs from an SD memory card to a PLC with the a
master memory.
There is not enough general-purpose memory available in the
destination PLC.
The PLC is set to RUN mode. Change to REMOTE mode or
PROG. mode.
Check whether a device that cannot be forced in PROG. mode
has been forcibly turned on or off.
No SD memory card is inserted.
The functions for data logging, line graph and alarm history jointly
use the SRAM.
Transfer all data from GTWIN to avoid the error message.
Data cannot be written onto the SD memory card. Check whether
the SD memory card is write-protected.
The SD memory card is full.
The command to stop writing to the SD card has been sent. Turn
off the command.
The command to stop writing to the SD card has been sent. Turn
off the command.
Transfer all data.
The device value setting for the index modifier is out of range. Set
a value that is in range.
The value set at the start of the line graph function is out of range.
Set a value that is in range.
Setting a value greater than 32 when "no. of plots" is selected will
also result in this error message.
The IP address for Ethernet is not specified correctly. Check the
IP address for the GT unit.
The subnet mask for Ethernet is not specified correctly. Check the
subnet mask for the GT unit.
The default gateway for Ethernet is not specified correctly. Check
the default gateway for the GT unit.
The port no. for Ethernet is not specified correctly. Check the port
6.3 GT Series Error Codes
237