Fp Monitor; Installing Fp Monitor On The Gt - Panasonic GTWIN Reference Manual

GT Panel System Menu

2.7 FP Monitor

With FP Monitor, you can check and control an FP series PLC connected to the GT. The
following functions are available:

Read and write system registers

Read and write registers (bit and word data)

Force registers on/off

Monitor shared memory

Monitor error status

Manage passwords
FP Monitor supports all FP series PLCs developed since the mid 1990s. It does not support
older models, e.g. FP-1, FP-M, etc.
User memory required (FROM)
The user memory required by the FROM for FP Monitor depends on the GT model.
GT model
GT02
GT02L
GT05M, GT05G, GT32M
GT03-E, GT05S, GT32T,
GT32-R, GT32-E
GT12

2.7.1 Installing FP Monitor on the GT

Before you can use FP Monitor, you need to transfer the FP Monitor screens to the GT. There
are two methods to transfer the FP Monitor screens:

Via GTWIN

Via SD memory card
Via GTWIN
1. File  Transfer
2. Activate the checkbox "FP Monitor"
You can activate other checkboxes if you wish to transfer other data, too.
3. Check that "Direction" is set to "GTWIN->GT"
80
User memory required
146kb
123kb
264kb
329kb
183kb
GTWIN Reference Manual