Panasonic GTWIN Reference Manual page 186

GTWIN Reference Manual
Basic Setup Operation Modes
Please refer to the "Switch Part" dialog (see p. 182) for all settings other than for the "Basic
Setup" tab.
Option button
Bit Set
Bit Reset
Momentary
Alternate
Change Screen
Others
Multi Function
"Others" option button
Selection
Value Set
Add
Subtract
Change to GT Configuration
Thumbwheel SW
Back to Previous Screen
Change Language No.
Change Language No.
(INC/DEC)
Description
Sets, i.e. turns on, the specified bit device (e.g. R100) specified in the "Device
Setting" box.
Resets, i.e. turns off, the specified bit device.
Turns on the specified bit device as long as the switch part is pressed.
Reverses the status of the specified bit device (ON or OFF) each time the
switch part is pressed.
Switch to the GT settings screen selected via the option button.
See following table.
See section on Multi Function (see p. 187).
Description
Set a defined value in a defined data format to a defined output.
Augend (Augend/Minuend) + addend (Value) = sum (Output)
Add a "Value" in the data format defined to the value stored in the
"Augend/Minuend". The sum is stored in the device defined for "Output".
Minuend (Augend/Minuend) - subtrahend (Value) = difference (Output)
Subtract a "Value" in the data format defined from the value stored in the
"Augend/Minuend". The difference is stored in the device defined for "Output".
Switch to the GT settings screen selected via the option button.
Selecting this option will make the function switch behave like a thumbwheel
switch, i.e. you can turn it up or down (add or subtract values) and it has
definite limits.
Select INC to add or DEC to subtract 1 to the hexadecimal digit position
specified.
Digit specifies the hexadecimal position in word data. Enter a value between 0
and 3.
W ord (Hex):
Digit: 3 2 1 0
Under Inc/Dec Range, you define the min. and max. limits of the thumbwheel
switch. If you select Does not cycle between Max. and Min., the value will
not reset when it reaches its max. or min. value but remain at the limit.
Switches to the previous screen.
Changes to the language no. as defined in the multi-language exchange list
(see p. 159).
Increases or decreases the language no. as defined in the multi-language
exchange list (see p. 159) within the range defined.
When the maximum or minimum language number has been reached, the
process will cycle unless you activate "Does not cycle between Max. and Min."
5.2 Function Switch Parts
185