Introducing GTWIN
Start-Up Screen tab
With the settings displayed above, "Start-up Screen No." 2 is displayed for 10 seconds.
Switches, lamps and other devices that require addresses and hence communication will not
be displayed during this time.
Screen 2, the temporary start-up screen
After this delay, the screen corresponding to the number stored in the initial address of the
word device under "Basic Communication Area to PLC" (see p. 24) in the "Basic Setup"
parameters under "GT Configuration" will be displayed.
1.6.6 Setup 1
Which tabs and what appears on them may differ depending on which GT
model you have selected.
32
GTWIN Reference Manual