Vlan Configuration Example - HP V1910 Switch Series User Manual

Item
Link Type
PVID
Delete
Return to VLAN configuration task list (approach

VLAN configuration example

Network requirements
As shown in
Trunk port GigabitEthernet 1/0/1 of Switch A is connected to trunk port GigabitEthernet 1/0/1 of

Switch B.
The PVID of GigabitEthernet 1/0/1 is VLAN 100.

GigabitEthernet 1/0/1 permits packets of VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to

pass through.
Figure 127 Network diagram for VLAN configuration
Configuration procedure
Configure Switch A
1.
# Configure GigabitEthernet 1/0/1 as a trunk port and configure VLAN 100 as its PVID.
Select Device > Port Management from the navigation tree and click the Setup tab to enter the page
shown in Figure
Description
Set the link type of the selected ports, which can be access, hybrid, or trunk.
This item is available when the Link Type option is selected in the Select
membership type area.
Set the PVID of the selected ports.
If you select Delete, you restore the PVID to VLAN 1.
This item is available when the PVID option is selected in the Select membership
type area.
Figure 127:
128.
II).
141