HP V1910 Switch Series User Manual page 80

Table 19 Port configuration items
Item
Port State
Speed
Duplex
Link Type
PVID
Description
Enable or disable the port. Sometimes, after you modify the operation
parameters of a port, you need to disable and then enable the port to have the
modifications take effect.
Set the transmission rate of the port.
Available options include:

10: 10 Mbps

100: 100 Mbps

1000: 1000 Mbps

Auto: auto-negotiation

Auto 10: auto-negotiated to 10 Mbps

Auto 100: auto-negotiated to 100 Mbps

Auto 1000: auto-negotiated to 1000 Mbps

Auto 10 100: auto-negotiated to 10 or 100 Mbps

Auto 10 1000: auto-negotiated to 10 or 1000 Mbps

Auto 100 1000: auto-negotiated to 100 or 1000 Mbps

Auto 10 100 1000: auto-negotiated to 10, 100, or 1000 Mbps
IMPORTANT:
SFP optical ports do not support the 10 or 100 option.
Set the duplex mode of the port.

Auto: auto-negotiation

Full: full duplex

Half: half duplex
IMPORTANT:
Ethernet electrical ports whose transmission rate is configured as 1000 Mbps
and SFP optical ports do not support the half option.
Set the link type of the current port, which can be access, hybrid, or trunk. For
more information, see the chapter "VLAN configuration."
IMPORTANT:
To change the link type of a port from trunk to hybrid or vice versa, you must first
set its link type to access.
Set the default VLAN ID of the interface. For more information about setting the
PVID, see the chapter "VLAN configuration."
IMPORTANT:
To enable a link to properly transmit packets, be sure the trunk or hybrid ports at
the two ends of the link have the same PVID.
66