HP V1910 Switch Series User Manual page 294

 Click Apply.
# Enable the DHCP relay agent on VLAN-interface 1.
In the Interface Config field, click the

operations, as shown in
Figure 248 Enable the DHCP relay agent on an interface and correlate it with a server group
 Click on the Enable radio button next to DHCP Relay.
Select 1 for Server Group ID.

Click Apply.

NOTE:
Because the DHCP relay agent and server are on different subnets, you need to configure a static route or
dynamic routing protocol to make them reachable to each other.
icon of VLAN-interface 1, and then perform the following
Figure 248.
280