HP V1910 Switch Series User Manual page 420

Figure 384 The page for configuring an basic IPv4 ACL
Table 150 describes the configuration items for creating a rule for a basic IPv4 ACL.
Table 150 Configuration items for a basic IPv4 ACL rule
Item
Select Access Control List (ACL)
Rule ID
Operation
Check Fragment
Check Logging
Source IP Address
Description
Select the basic IPv4 ACL for which you want to configure rules.
Available ACLs are basic IPv4 ACLs that have been configured.
Select the Rule ID option and type a number for the rule.
If you do not specify the rule number, the system will assign one
automatically.
Select the operation to be performed for IPv4 packets matching the
rule.

Permit—Allows matched packets to pass.

Deny—Drops matched packets.
Select this option to apply the rule to only non-first fragments.
If you do no select this option, the rule applies to all fragments and
non-fragments.
Select this option to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the matched
packets, protocol that IP carries, source/destination address,
source/destination port number, and number of matched packets.
Select the Source IP Address option and type a source IPv4 address
406