Storm Constrain Configuration; Overview; Configuring Storm Constrain; Setting The Traffic Statistics Generating Interval - HP V1910 Switch Series User Manual

Storm constrain configuration

Overview

The storm constrain function limits traffic of a port within a predefined upper threshold to suppress packet
storms in an Ethernet. With this function enabled on a port, the system detects the amount of broadcast
traffic, multicast traffic, and unicast traffic reaching the port periodically. When a type of traffic exceeds
the threshold for it, the function, as configured, blocks or shuts down the port, and optionally, sends trap
messages and logs.
CAUTION:
Alternatively, you can configure the storm suppression function to control a specific type of traffic. Because
the storm suppression function and the storm constrain function are mutually exclusive, do not enable them
at the same time on an Ethernet port. For example, with broadcast storm suppression enabled on a port,
do not enable storm constrain for broadcast traffic on the port. The storm suppression function is
configured in Device > Port Management. For more information, see the chapter "Port management
configuration."
With storm constrain enabled on a port, you can specify the system to act as follows when a certain type
of traffic (broadcast, multicast, or unicast) exceeds the corresponding upper threshold:
Block—Blocks the port. The port is blocked and stops forwarding the traffic of this type until the type

of traffic drops down below the lower threshold. A port blocked by the storm constrain function can
still forward other types of traffic and collect statistics for the blocked traffic.
Shutdown—Shuts down the port. The port is shut down and stops forwarding all types of traffic. To

bring up the port, select Device > Port Management to configure the port, or cancel the storm
constrain setting on the port.

Configuring storm constrain

Setting the traffic statistics generating interval

Select Device > Storm Constrain from the navigation tree to enter the page shown in
Interval for generating traffic statistics text box, input the traffic statistics generating interval for storm
constrain.
90
Figure 74. In the