HP V1910 Switch Series User Manual page 133

Figure 100 Create an SNMP view (2)
Configure the parameters of a rule and click Add to add the rule into the list box at the lower part
3.
of the page.
Configure all rules and click Apply to crate an SNMP view. Note that the view will not be created
4.
if you click Cancel.
Table 43 Configuration items for creating an SNMP view
Item
View Name
Rule
MIB Subtree OID
Subtree Mask
Adding rules to an SNMP view
Click the
1.
rule for the view ViewDefault window appears as shown in
Configure the parameters, and click Apply to add the rule for the view.
2.
configuration items for creating an SNMP view.
Description
Set the SNMP view name.
Select to exclude or include the objects in the view range determined by the MIB
subtree OID and subtree mask.
Set the MIB subtree OID (such as 1.4.5.3.1) or name (such as system).
MIB subtree OID identifies the position of a node in the MIB tree, and it can uniquely
identify a MIB subtree.
Set the subtree mask.
If no subtree mask is specified, the default subtree mask (all Fs) will be used for
mask-OID matching.
icon corresponding to the specified view on the page as shown in
Figure
119
Figure 98, the Add
101.
Table 43 describes the