Default Route; Configuring Ipv4 Routing; Displaying The Ipv4 Active Route Table - HP V1910 Switch Series User Manual

Default route

A default route is used to forward packets that match no entry in the routing table. Without a default route,
the packet is discarded.
An IPv4 static default route has both its destination IP address and mask being 0.0.0.0.

Configuring IPv4 routing

Displaying the IPv4 active route table

Select Network > IPv4 Routing from the navigation tree to enter the page shown in
Figure 226 Active route table
Table 104 Description of the fields of the active route table
Field
Destination IP Address
Mask
Protocol
Preference
Next Hop
Interface
Description
Destination IP address of the route
Mask of the destination IP address
Protocol that discovered the route
Preference value for the route
The smaller the number, the higher the preference.
Next hop IP address of the route
Output interface of the route. Packets destined for the destination IP
address will be forwarded out the interface.
260
Figure 226.