HP V1910 Switch Series User Manual page 53

 On the page of the Setup tab, perform the following configurations, as shown in
Figure 27 Configure a stack port on Switch A
In the Port Settings area, select the check box before GigabitEthernet1/0/1.

Click Enable.

Configure the member switches
2.
# On Switch B, configure local ports GigabitEthernet 1/0/2 connecting with switch A, GigabitEthernet
1/0/1 connecting with Switch C, and GigabitEthernet 1/0/3 connecting with Switch D as stack ports.
39
Figure 27.