Configuring SNMPv3
Perform the tasks in
Table 41 SNMPv3 configuration task list
Task
Enabling SNMP
Configuring an SNMP
Configuring an SNMP
Configuring an SNMP
Configuring SNMP trap
Enabling SNMP
Select Device > SNMP from the navigation tree to enter the SNMP configuration page, as shown in
97. On the upper part of the page, you can select to enable or disable SNMP and configure parameters
such as SNMP version; on the lower part of the page, you can view the SNMP statistics, which helps you
understand the running status of the SNMP after your configuration.
Table 41
to configure SNMPv3:
Remarks
Required
The SNMP agent function is disabled by default.
Optional
After creating SNMP views, you can specify an SNMP view for an
SNMP group to limit the MIB objects that can be accessed by the SNMP
group.
Required
After creating an SNMP group, you can add SNMP users to the group
when creating the users. Therefore, you can realize centralized
management of users in the group through the management of the
group.
Required
Before creating an SNMP user, you need to create the SNMP group to
which the user belongs.
Optional
Allows you to configure that the agent can send SNMP traps to the
NMS, and configure information about the target host of the SNMP
traps
By default, an agent is allowed to send SNMP traps to the NMS.
116
Figure