Protocols And Standards; Configuring Radius; Configuration Task List - HP V1910 Switch Series User Manual

 Vendor-Data—Indicates the contents of the sub-attribute.
Figure 331 Segment of a RADIUS packet containing an extended attribute

Protocols and standards

 RFC 2865, Remote Authentication Dial In User Service (RADIUS)
RFC 2866, RADIUS Accounting

RFC 2867, RADIUS Accounting Modifications for Tunnel Protocol Support

 RFC 2868, RADIUS Attributes for Tunnel Protocol Support
RFC 2869, RADIUS Extensions


Configuring RADIUS

Configuration task list

NOTE:
The RADIUS scheme configured through the web interface is named system.
If there is no RADIUS scheme named system in the system, when you select Authentication > RADIUS
to enter the RADIUS module, a scheme named system is created automatically.
Table 129 RADIUS configuration task list
Task
Configuring RADIUS
authentication servers
Configuring RADIUS
accounting servers
Configuring RADIUS
parameters
Description
Required
Configure the information related to the primary and
secondary RADIUS authentication servers.
By default, no RADIUS authentication server is configured.
Optional
Configure the information related to the primary and
secondary RADIUS accounting servers.
By default, no RADIUS accounting server is configured.
Required
Configure the parameters that are necessary for information exchange between the
device and RADIUS servers.
For more
information, see
"Configuring
RADIUS servers."