Protocols And Standards; Configuring Mstp; Configuration Task List; Configuring An Mst Region - HP V1910 Switch Series User Manual

 TC-BPDU (a message that notifies the device of topology changes) guard

Protocols and standards

IEEE 802.1d, Media Access Control (MAC) Bridges

IEEE 802.1w, Part 3: Media Access Control (MAC) Bridges—Amendment 2: Rapid Reconfiguration

 IEEE 802.1s, Virtual Bridged Local Area Networks—Amendment 3: Multiple Spanning Trees

Configuring MSTP

Configuration task list

Perform the tasks described in
Table 74 MSTP configuration task list
Task

Configuring an MST region

Configuring MSTP globally
Configuring MSTP on a port
Displaying MSTP information of
a port
Configuring an MST region
Select Network > MSTP from the navigation tree to enter the page as shown in
Table 74 to configure MSTP.
Remarks
Optional
Configure the MST region-related parameters and VLAN-to-MSTI mappings.
By default, the MST region-related parameters adopt the default values, and
all VLANs in an MST region are mapped to MSTI 0.
Required
Enable MSTP globally and configure MSTP parameters.
By default, MSTP is enabled globally; and all MSTP parameters have
default values.
Optional
Enable MSTP on a port and configure MSTP parameters.
By default, MSTP is enabled on a port, and all MSTP parameters adopt the
default values.
Optional
Display MSTP information of a port in MSTI 0, the MSTI to which the port
belongs, and the path cost and priority of the port.
185
Figure 166.