Kinematic (Stop & Go) Surveying For Rover Stations - Topcon GR-5 Operator's Manual

GR-5 Receiver Setup and Survey
Kinematic (Stop & Go)
Surveying for Rover Stations
In a kinematic stop and go survey, the stationary receiver (Base
station) is set up at a known point such as a survey monument, or an
unknown point. The receiver continually tracks satellites and logs raw
data into its memory. The Rover receiver is set up at an unknown
point and collects data in static mode for 2 to 10 minutes. When
finished, assign the Rover to kinematic status and move to the next
survey point. At this point, and each subsequent point, the receiver
changes to static mode to collect data. The Rover is in kinematic
mode when moving. The Rover is in static mode while collecting
data.
Perform the following to set up kinematic surveying for Rover
Stations:
1. Set up the Rover at an unknown point and press power. Allow
the Rover to collect static data for two to ten minutes. The REC
LED will be orange.
2. Check the STAT light for satellites tracked.
3. When finished, press the FUNCTION button for less than 1
second to assign the Rover to kinematic.
TIP
4. Move the Rover to the next location (survey point), and press the
FUNCTION button for less than a second to collect the data in
static mode for two to ten minutes.
5. Repeat steps three and four until all points have been surveyed.
The occupation time for the points depends on the same factors as
for the static survey method.
6. When finished, press the FUNCTION button for one to five
seconds to stop logging data. Turn off the Rover if needed.
4-12
Remember, if the REC LED blinks green, the
current mode is dynamic, if it blinks orange, the
current mode is static.
GR-5 Operator's Manual