Tube Setup - J&J Amusements Bumper Boat 2014 Service Manual

TUBE SETUP

Fig. 1
Fig. 3
Inflate and deflate boat tubes quickly with this
4hp vacuum/blower! J&J# 2-60-0124
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
Fig. 2
Fig. 5
Fig. 4
Carefully unfold the tube and lay it flat on the boat box top.
Note: Boat hulls are normally packaged with their correctly
Fill the tube with a Super Tube fill adapter
(#00367) as shown in figures 1 & 2, a Super Tube pressure
test adapter/filler (#2-60-A0006) as shown in figures 3 & 4,
or a vacuum/blower (J&J #2-60-0124) as shown in figure 5.
Carefully inflate the tube to the recommended 3 PSI.
Always use a low-pressure gauge, such as J&J #3-96-0024,
to accurately measure tube pressure.
NOTICE: TUBES SHOULD BE FILLED COLD AS AIR PRES-
(See Super Tube Inflation on page 2-14).
After inflating, make sure the valve is closed by pushing the
Check the valve for leaks by applying a solution of soapy
If bubbles form, the valve needs to be tightened.
With the tube inflated, insert Super Tube valve tightening tool
Repeat as needed until no bubbles form.
color-coordinated tube.
SURE CHANGES WHEN HOT.
valve in and turning it clockwise.
(J&J #2-60-0123).
Turn nut 1/8th turn.
Recheck with soapy water solution.
503-304-8899
0-25
water.