J&J Amusements Bumper Boat 2014 Service Manual page 114

3-26
SOLID STATE SWITCH
Remove the magnetic trigger
(see page 3-19).
Remove the wire leads from the power post
(see wiring diagram on page 4-19).
On the under-side of the motor, remove the solid state switch
mounting nuts.
Remove the solid state switch.
Note:
There is NO left or right solid state switch; it can be
installed on the squirt (blue rod) or motor (green rod) side.
The LED light on the switch must face the inside of the con-
trol rods
(solid state switch part # 2-30-A0002).
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com