J&J Amusements Bumper Boat 2014 Service Manual page 86

2-18
J&J Supertube II on electric powered Blaster boat
J&J's Supertube is a great eye pleaser for your boat pond. The Supertube is constructed of a UV resistant Urethane material. The Supertube's
material allows for easy storage, it can be folded and boxed up and then re-inflated in the spring. Patching this tube is easy with J&J's tube
patch kit. Unprecedented guarantee on seam breakage for 3 years. Individual panels can be replaced at the factory. And best of all, the
Supertube only weighs 12 pounds!
003370, Supertube repair kit
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com
Place the patch over the damaged tube surface and
use roller or old spoon to squeeze any air out of
Wait at least 24 to 48 hours before reinflating the
Pressure test the tube by inflating it and checking
If desired, leave the tube inflated overnight and
recheck it before putting it back into service.
When patching, the relative humidity must be less
than 70%, preferably as low as 40%. Temperature
should be 64°C to 77°C ( 147.2°F. to 170.6°F.).
Bond strength drops very rapidly with heat or high
humidity. Don't patch the tube near water or in
2-60-0072, 4OZ glue 003371, Supertube maintenance & repair kit
the patch, pressing the material together.
the patch with soapy water.
tube.
NOTICE:
direct sunlight.