Monthly Maintenance Chart - J&J Amusements Bumper Boat 2014 Service Manual

0-10
MONTHLY SERVICE SCHEDULE (Electric)
Below are explanations of service listed in the monthly maintenance charts on previous page.
Explanations of monthly maintenance shall include, but are not limited to the following:
1. SB-120 PLUG(S):
Make sure that the plug is lubed with dielectric grease. Inspect the plug for deep grooving or signs of arcing.
2. MOTOR: Remove hood and check connections. Spray motor and wiring with corrosion block (J&J #99101).
3. BATTERIES: Check for corrosion, and spray terminals with battery protectant (J&J #99101). Fill batteries with distilled
water weekly, or as needed. Make sure compartment is ventilated.
‹ DANGER › : ***READ BATTERY SAFETY PRECAUTIONS BEFORE HANDLING BATTERIES***
4. PIVOT: Turn motor and check for smooth operation. If motor doesn't turn easily, visually inspect pivot and grease if
necessary. Electric motor can turn 270°. Motor stops must be in place and in working order.
5. MOTOR /CHARGER POWER CABLES: Disconnect and grease terminals. Look for signs of wear (Replace as need-
ed).
6. SUMP PUMP: Clean strainer as needed. Check pump operation. If pump is not cycled periodically, check all wiring
connections. Repair or replace pump as needed.
7. PROPELLER GUARD: Inspect for damage or foreign materials. Replace if damaged.
‹ SAFETY ITEM › ***WARNING: DO NOT OPERATE IF PROPELLER GUARD IS DAMAGED OR MISSING***
8. HULL: Keep clean and wax every 200 hours or every 2 months. Use a UV protectant weekly to reduce color fading
(J&J part # 3-60-0034).
9. GENERAL WIRES & CONNECTIONS: Check all wires and connections for damage and corrosion. Clean or replace
as needed.
10. ANODE: Clean monthly. For year-round parks, replace anode every 6 months. For seasonal parks, replace anode
at end of the season.
11. SQUIRTER: Replace filter if necessary. Check integrity of hose, mount and pump. Check pump inlet for obstruc-
tions. Replace as needed.
12. TUBE: Clean with mild detergent. Check condition of tube daily. Check tube pressure weekly using low pressure
gauge (J&J #3-96-0024) and set pressure to 2-3 PSI.
NOTE: ALL NECESSARY REPAIRS NEED TO BE DONE BEFORE BOAT IS OPERATED. USE J&J AMUSEMENTS
OR EQUIVALENT REPLACEMENT PARTS. INSPECTIONS SHOULD BE DONE BY TRAINED AND QUALIFIED
PERSONNEL.