J&J Amusements Bumper Boat 2014 Service Manual page 128

3-40
Cut the zip tie to remove the hose from the handle bar base.
Carefully remove the wiring and hose from the handlebar
plate.
Remove the two bolts from the drive shaft housing.
Note
A metal anode is mounted between the squirt pump and drive-
shaft housing.
When installing the anode, apply a small amount of silicone
on each bolt.
CORROSION SOLUTION! CORROSION BLOCK PRODUCTS
AVAILABLE AT J&J.
503-304-8899
12 OUNCE AEROSOL - #99101
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com