Bilge Pump Fuse (Electric Only) - J&J Amusements Bumper Boat 2014 Service Manual

1-7

BILGE PUMP FUSE (Electric only)

REMOVAL/INSTALLATION
The bilge pump fuse is located on the back of the boat top to
the left of the vent plate.
With a flat screwdriver, push and turn counterclockwise 1/4
turn.
Remove the fuse and holder by pulling outward.
Remove the fuse from the holder.
Check for continuity through the fuse with a multimeter
(see page 4-6 for a fuse test).
NOTE: The replaceable fuse is a 3-amp time-delay/slow-blow
cartridge-style fuse. Using any fuse type other than this specifi-
cation could result in poor performance and/or pump failure.
Replace as needed.
REPLACEMENT 3 AMP FUSES,
J&J # 2-70-0104
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com