J&J Amusements Bumper Boat 2014 Service Manual page 14

0-14
Pre-Opening Checklist - Explanation (Electric)
Below are explanations of service listed in the Pre-Opening Checklist chart on previous page.
Explanations of Pre-Opening Checklist shall include, but are not limited to the following:
BOATS:
TUBE - Check air pressure using a high-quality, low-pressure gauge. Super Tube should be inflated to 2-3 PSI.
HULL - Check for cracks and missing hardware.
.
RECEIVER - Check for loosening or missing hardware, and cracking around mount.
HANDRAILS & HARDWARE - Check for loosening and missing hardware.
SUMP PUMP - View through hull vent to check for excessive water.
BATTERIES - Check volt meter for full charge of 24-26 volts. Viewing through hull vent, check battery terminals for vis-
ible corrosion.
MOTOR:
MOTOR - Visually and physically check motor operation, "go" and "squirt" function, loose hardware, grips, handlebar
condition and abnormal noises during operation.
MOTOR POWER CABLE - Check for bare wires, proper connection, and any signs of excessive heat or melting.
‹ WARNING › ***DO NOT OPERATE UNTIL DAMAGED CONNECTORS AND/ OR CABLE ARE REPLACED***
PIVOT - Check for smooth operation by rotating motor lock to lock.
PROP GUARD - Check for damage and foreign material.
‹ WARNING › ***DO NOT OPERATE IF PROPELLER GUARD IS DAMAGED OR MISSING***
NOTICE: ALL NECESSARY REPAIRS NEED TO BE DONE BEFORE BOAT IS OPERATED. USE OF J&J AMUSEMENTS
OR EQUIVALENT REPLACEMENT PARTS IS RECOMMENDED. INSPECTIONS SHOULD BE DONE BY QUALIFIED
PERSONNEL.