J&J Amusements Bumper Boat 2014 Service Manual page 161

6-5
DECAL REMOVAL AND INSTALLATION
REMOVAL
Use a hot air gun to heat the decal.
The heat is not for melting away the decal, but to heat the
adhesive enough to removal the decal.
Repeat until the decal is completely removed.
Apply a small amount of WD-40 to a clean cloth
(the cloth should be damp, but not soaked).
Wipe away the glue on the fiberglass using the moistened
cloth.
INSTALLATION
Clean the surface with a grease-cutting liquid detergent
and water.
Rinse with fresh water, then dry with a lint-free cloth.
Peel the backing paper from the new decal starting at the
edge
(be careful not to touch the decal adhesive).
Using a spray bottle filled with water, spray the glue side
of the decal before applying.
This will allow a bubble-and wrinkle-free application.
Wet the fiberglass with the spray bottle and place the
decal in position .
Hold a squeegee in such a way that you will be able to
make easy, overlapping strokes.
Begin in the center and squeegee the entire decal, working
from the center to outer edges to remove all air from under
the decal.
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com