J&J Amusements Bumper Boat 2014 Service Manual page 53

1-19
TRIM INSTALLATION/REMOVAL
The boat trim is mounted with 9 stainless steel rivets
and double-sided tape.
REMOVAL
To remove the old trim, first drill out the rivets and
pull the trim off of the fiberglass.
Make sure to remove any trim adhesive and thor-
oughly clean off the surface of the fiberglass before
installing the new boat trim.
INSTALLATION
Heat trim before installing.
Peel off 2"of tape backing.
Line up the trim with the center of the vent plate.
Carefully wrap the trim around the boat top, pull-
ing the tape backing off in 2 inch sections at a
time.
Cut off any excess trim.
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com