Tube Setup - J&J Amusements 24v 1750 rpm Service Manual

TUBE SETUP

Fig. 1
Fig. 3
Infl ate and defl ate boat tubes quickly with this 4hp
vacuum/blower! J&J# 2-60-0124
phone: 1-800-854-3140 | 1-503-304-8899 fax: 1-800-366-7505 | 1-503-304-1899 www.jjamusements.com
Fig. 2
Fig. 5
Fig. 4
Carefully unfold the tube and lay it fl at on the boat box top.
Note: Boat hulls are normally packaged with
their correctly color-coordinated tube.
Fill the tube with a Super Tube fi ll adapter
(#00367) as shown in fi gures 1 & 2, a Super Tube pressure test
adapter/fi ller (#2-60-A0006) as shown in fi gures 3 & 4, or a
vacuum/blower (J&J #2-60-0124) as shown in fi gure 5.
Carefully infl ate the tube to the recommended 3 PSI.
Always use a low-pressure gauge, such as J&J #3-96-0024,
to accurately measure tube pressure.
NOTICE: TUBES SHOULD BE FILLED COLD AS
AIR PRESSURE CHANGES WHEN HOT.
(See Super Tube Infl ation on page 2-14).
Aft er infl ating, make sure the valve is closed by
pushing the valve in and turning it clockwise.
Check the valve for leaks by applying a solution of soapy water.
If bubbles form, the valve needs to be tightened.
With the tube infl ated, insert Super Tube valve tightening tool
Recheck with soapy water solution.
Repeat as needed until no bubbles form.
25
(J&J #2-60-0123).
Turn nut 1/8th turn.