J&J Amusements Bumper Boat 2014 Service Manual page 125

3-37
SQUIRT PUMP ASSEMBLY (J&J# 2-60-A0014)
General Information ..................................................3-37 Squirt Nozzle ............................................................3-41
Squirt Pump Assembly ...............................................3-38
The squirt pump is a sealed, 24VDC, brushless, submersible-style pump that is powered through the same type of solid
state switch and magnetic trigger system that operates the motor relay.
The squirt pump is a sealed unit, and repairable problems center around debris in the impeller. The output water tube
feeds through an in-line filter, then a quick-release coupler (to allow motor cover removal; see page 3-2) to the squirt
nozzle.
The electrical supply feeds from the main motor power posts, through the fuse holder (the slow-blow fuse is the same
that is used by the bilge pump), is located in the front of the motor just under the motor cover, and can be removed
and checked without removing the motor cover.
The squirt pump is controlled by interrupting the ground side of the circuit, via the solid state switch or the boat cap-
tain remote control unit (standard equipment on U.S. models only).
To isolate the pump from the solid state switch and boat captain, disconnect the yellow lead that goes from the fuse
holder to the micro-switch and jumper it directly to the ground post. The pump should run continuously; if not,
double-check the fuse by disconnecting the fuse holder wires and use DVOM to test for continuity through the fuse.
If the pump runs when the micro-switch and boat captain are bypassed, then the circuits must be tested.
503-304-8899
Specifications subject to change without notice - Check our website for valuable information including videos, workshop and operations manuals. www.jjamusements.com